Printer is really good - just wish did not have the bad pixel issue -
off the bat also invested in an enclosure to keep the temps steady
and an exhaust . Prints come out really good ( supposedly 8K resolution ) - way better than Shapeways use to be.
off the bat also invested in an enclosure to keep the temps steady
and an exhaust . Prints come out really good ( supposedly 8K resolution ) - way better than Shapeways use to be.
Started with Elegoo 8k Space gray resin - since then ( 2 and half months now went through
- Elegoo 8K space gray
- AnyCubic ABS like Gray
- AnyCubic Standard + Gray
- Siraya Tech ABS like Gray
- Elegoo Water-wash ( not suitable for train models in my opinion )
Latest resin to try was
- Siraya Tech Tough gray
- Siraya Tech Tenacious ( as an additive to other resins especially for ABS like )
Looking for a good resin / rein mix to achieve good quality / resolution and not to shrink too much / and not fragile.
Ultimate goal is to have clear, clear green and smoke clear windows for the models too. But at the moment need to replace the screen on the printer already ( bit short 2.5 months ? and have dead pixels already .... ) . Should have the new screen in few days - then the replacement FUN will begin.